Important Information
6
Lamp Caution: Please read
before operation
Due to the lamp being sealed in a
pressurized environment, there is a small
risk of explosion, if not operated correctly.
There is minimal risk involved, if the unit is
in proper working order, but if damaged or
operated beyond the recommended hours,
the risk of explosion increases. Please note
that there is a warning system built in, that
displays following message when you reach
a preset operating time “Bulb Over Time”.
When you see this message please contact
your dealer for a replacement. If the lamp
does explode, smoke will be discharged
from the vents located on the back of the
unit. Do not stand in front of the vents
during the operation. This smoke is
comprised of glass in particulate form and
Xenon gas, and will not cause harm if kept
out of your eyes. If your eyes have been
exposed to this gas, please flush your eyes
out with water immediately and seek
immediate medical attention. Do not rub
your eyes! This could cause serious injury.
WARNING:
• Do not look into the lens while the
projector is on. Serious damage to your
eyes could result.
• When main body is damaged, cooling
fluids may come out of internal part.
DO NOT touch and drink the cooling fluid.
When the cooling fluids are swallowed or
contacted with your eyes, please consult
medical attention immediately.
CAUTION
Never unplug the projection head power
plug from the outlet or disconnect the
breaker connected to the AC power cable of
the lamp power supply under the following
conditions. Doing so can cause damage to
the projector:
• While projecting image
• While the projector is turned on
• While cooling after the lamp has been
turned off. (The POWER indicator blinks in
white while the fan is running, and the
LCD screen displays “cooling...”. The
cooling fan continues to operate for 5
minutes.)
Handling the Battery
• Take care when handling the battery, as it
could cause fire, injury, or damage to
surrounding objects.
- Do not short out, dismantle, or place
batteries in a fire.
- Do not use the battery other than as
designated.
- Ensure that you have the batteries’
polarity (+/-) aligned correctly.
• Dispose of used batteries according to
your local regulations.
• There is a battery mounted on the
electronic circuit board within the main
unit. When disposing of the main unit, do
not dismantle the device or remove the
internal circuit board, and contact the
shop where you purchased the product or
your local government agency.
Disposing of your used product
EU-wide legislation as
implemented in each Member
State requires that used electrical
and electronic products carrying
the mark (left) must be disposed of
separately from normal household
waste. This includes projectors and
their electrical accessories or
lamps. When you dispose of such
products, please follow the
guidance of your local authority
and/or ask the shop where you
purchased the product. After
collecting the used products, they
are reused and recycled in a proper
way. This effort will help us reduce
the wastes as well as the negative
impact to the human health and
the environment at the minimum
level. The mark on the electrical
and electronic products only
applies to the current European
Union Member States.
To Next Page
Loading...
Need help?
General
