NEC NEAX 2000 IPS - DTMF Signal Sender

CHAPTER 3 SYSTEM DATA PROGRAMMING
– 142 –
NWA-008855-001 Rev.1.0
avch3001.fm
DTMF Signal Sender
This programming is available only for the Adjunct Type (Analog Interface).
DESCRIPTION DATA
Specify the DTMF signal width. •
(1)
(2)
Y=26
00-63: Trunk Route No.
0: 64 ms.
1 : 128 ms.
Specify available timing to send DTMF sig-
nals after call origination from a PS by CM35
Y=45 or CM35 Y=46 or CM41 Y=0>27. Only
the shortest value data becomes effective
among the above.
•
(1)
(2)
CM35 Y=45
DP Sender Release Timing
00-63: Trunk Route No.
0 : 2 seconds
1 : 4 seconds
2 : 6 seconds
3 : 8 seconds
4 : 12 seconds
5 : 14 seconds
6 : 16 seconds
7 : 10 seconds
•
(1)
(2)
CM35 Y=46
DTMF Sender Release Timing
00-63: Trunk Route No.
0 : 2 seconds
1 : 4 seconds
2 : 6 seconds
3 : 8 seconds
4 : 12 seconds
5 : 14 seconds
6 : 16 seconds
7 : 10 seconds
•
(1)
(2)
CM41 Y=0
27: Interdigit Pause on Outgoing Call
03-14: 3-14 seconds
(1 second increment)
If no data is set, the default setting is 7 seconds.
START
CM35
CM35
CM41
END
WCS FEATURE PROGRAMMING