CHAPTER 2 INSTALLATION
– 74 –
NWA-008855-001 Rev.1.0
avch2001.fm
VLAN Data Assignment
VLAN data assignment is available only from the PC.
NOTE: After VLAN data assignment is completed, communication is available only in assigned net-
work including communication with the PC used for this assignment.
STEP1:
Connect the IP-CS and the PC. Page 68
STEP2:
Log into the IP-CS from the PC. Page 69
STEP3:
Register data.
By the command registration, assign and read the data. Finally, reboot the IP-CS and load the
assigned the data.
(a) Set VLAN ID and priority
Command: set vlan
Example:
VLAN ID: 4094
Priority: 0
The “set done” message is indicated when the IP-CS has received the assigned data normally.
Assigned data can be read by entering “show vlan” command. To delete the VLAN ID “0”, set
the priority as “0”.
(b) Validate the VLAN
Command: set vlansw on
The “set done” message is indicated when the IP-CS has received the assigned data normally.
Assigned data can be read by entering “show vlansw” command. To invalidate VLAN, set “set
vlansw off”.
>set vlan 4094 0
>set vlansw on
SETUP OF IP-CS
To Next Page
Loading...
