NEC NEAX 2000 IPS - Virtual Station Data Programming

CHAPTER 3 SYSTEM DATA PROGRAMMING
– 121 –
NWA-008855-001 Rev.1.0
avch3001.fm
VIRTUAL STATION DATA PROGRAMMING
NOTE: Virtual trunk is not used from Series 3300 software. When using the office data in Series 3200
R6.2 software or before, execute the office data conversion. See “Office Data
Conversion”. Page 88
Office data settings for virtual trunk that are shown below are not required.
CM5A Y=00
CM30 Y=00, 02, 03, 04, 05, 40, 41, 42, 43
CM35 Y=00, 01, 04, 05, 09, 20, 76, 98
CM12 Y=16
CM85 Y=0-7
DESCRIPTION DATA
Assign the FP number to the FP for virtual sta-
tion of PS.
NOTE: For the first data 56-63 of CM05
Y=1-7, follow the initial setting.
•
(1)
(2)
Y=0
56-63: FP No.
00: FP (for Virtual Station of PS)
Assign the virtual PIM number that is con-
trolled by the FP for virtual station of PS.
NOTE: We recommend using Virtual PIM
No. 08-11.
•
(1)
(2)
Y=8
56-63: FP No.
00 XX
XX: 08-11, 14-15: Virtual PIM No.
Assign a Virtual station number to the required
LEN.
NOTE 1: Do not assign the same station num-
ber to the Virtual station number
and PS station number.
NOTE 2: For Short Message Notification
(OAI), maximum 4 digits Virtual sta-
tion number must be assigned.
(1)
(2)
XX ZZZ (LEN)
XX : 56-63: FP No.
ZZZ: 000-063: Port No.
X-XXXXXXXX:Virtual Station No.
NOTE 1
NOTE 2
START
CM05
INITIAL
INITIAL
CM14
A
VIRTUAL STATION DATA PROGRAMMING