NEC NEAX 2000 IPS - Multi-Line Operation-PS

CHAPTER 3 SYSTEM DATA PROGRAMMING
– 146 –
NWA-008855-001 Rev.1.0
avch3001.fm
Multi-Line Operation-PS
To provide this feature, the BISON type PS, and BS21A, BS31 or BS301 are required.
DESCRIPTION DATA
Assign a subline PS station number to the Vir-
tual PS LEN.
(1)
(2)
000-511: Virtual PS LEN
X-XXXXXXXX: Subline PS Station No.
Assign the subline PS station number to each
primary PS station.
•
(1)
(2)
Y=01
X-XXXXXXXX: Primary PS Station No.
downloaded (CM1C)
X-XXXXXXXX: Subline PS Station No.
assigned by CM1C
Specify the Terminal type of PS as 0. •
(1)
(2)
Y=14
X-XXXXXXXX: Primary/Subline PS Sta-
tion No. assigned by
CM1C
0: PHS
Specify the kind of PS station as subline PS. •
(1)
(2)
Y=16
X-XXXXXXXX: Subline PS Station No.
assigned by CM1C
0: Subline PS
Provide the multi-line function to the Virtual
station number for the primary PS and subline
PS.
•
(1)
(2)
Y=05
X-XXXXXXXX: Virtual Station No.
assigned by CM14
0: Provided
Set the Control Signal Mode of the Calling
Area as Crowded Mode.
•
(1)
(2)
Y=10
00-31: Calling Area No.
02: Crowded Mode
Assign the Virtual station data for the sub line
PS as same as the primary PS.
See “VIRTUAL STATION DATA
PROGRAMMING”. Page 121
START
CM1C
CM1D
CM12
CMAE
CSH INITIAL
CM14
CM5A
A
WCS FEATURE PROGRAMMING