CHAPTER 2 INSTALLATION
– 49 –
NWA-008855-001 Rev.1.0
avch2001.fm
CS Installation
(1) Position and secure the CS Plate with three screws at the screw holes to wall as shown below.
When drilling holes on the wall in advance, the holes should be within
φ
3.0-3.2 mm, 20 mm depth.
(2) Put notches of the CS Plate into the slits of the reverse side of the CS, and secure the CS with a screw.
CS Installation
NOTE 1: Ensure that the wall or pillar to be used is strong enough to support the weight of the CS, so
that it does not shake, and has very little vibration.
NOTE 2: When taking off the CS from the CS plate, remove a screw which secures the CS, then lift and
pull the CS toward this side.
WALL
CS PLATE
SCREW TO WALL
SCREW TO SECURE CS
CS
INSTALLATION OF LEGACY CS
To Next Page
Loading...
