NEC NEAX 2000 IPS - LAN Cable Connection of ETHER Card

CHAPTER 2 INSTALLATION
– 84 –
NWA-008855-001 Rev.1.0
avch2001.fm
LAN Cable Connection of ETHER Card
Connect the LAN connector on the ETHER card and the Switching HUB by using a 10BASE-T/
100BASE-TX cable.
Connect CS to the Switching HUB that is connected to the LAN connector on the ETHER card.
ETHER-Switching HUB Cable Connection
NOTE: To provide the cascade connection of HUB, we recommend to connect maximum four HUBs by
10BASE-T or maximum two HUBs by 100BASE-TX cable.
8 Not used
7 Not used
6 RD -
5 Not used
4 Not used
3 RD +
2 TD -
1 TD +
Pins (RJ-45 Connector)
10BASE-T/
100BASE-TX CABLE
SWITCHING HUB (100 M)
MP
LAN
ETHER
CS
INSTALLATION OF IP-CS