CHAPTER 3 SYSTEM DATA PROGRAMMING
– 86 –
NWA-008855-001 Rev.1.0
avch3001.fm
HOW TO READ THIS CHAPTER
In the programming procedure, the meanings of (1), (2) and markings are as follows.
(1) : 1st Data
(2) : 2nd Data
: Initial Data
With the system data clear command (CM00, CM01), the data with this marking is auto-
matically assigned for each command.
: A reset of the MP card is required after data setting.
Press SW1 switch on the MP card.
: A reset of the CSH card is required after data setting.
Set the Make Busy switch to Up and then Down.
: Command with this marking can be used only under Off-Line mode of the MP card.
To set Off-Line mode,
(1) Set SW3 on the MP card to “2” or “3”.
(2) Press SW1 on the MP card.
For general description, operating procedure, service conditions of WCS features, refer to APPENDIX:
WCS FEATURES AND SPECIFICATIONS.
INITIAL
CSH INITIAL
OFF LINE
HOW TO READ THIS CHAPTER
To Next Page
Loading...
