CHAPTER 3 SYSTEM DATA PROGRAMMING
– 129 –
NWA-008855-001 Rev.1.0
avch3001.fm
WCS FEATURE PROGRAMMING
This section describes the programming for WCS dedicated features as follow.
• Announcement-PS No Answer/Announcement-PS Out of Cell Page 130
• Call Forwarding-Not Available Page 133 NOTE 1
• Call Forwarding-PS Out of Cell Page 134 NOTE 1
• Calling Name Display-PS Page 136 NOTE 2
• DTMF Signal Sender Page 142
• Group Call-Automatic Conference (6/10-Party) Page 143 NOTE 1
• Group Call-2 Way Calling Page 145 NOTE 1
• Multi-Line Operation-PS Page 146
• Number Sharing Page 148 NOTE 1
• PS Location Indication Page 150 NOTE 1
• Soft Phone Wireless Handset Page 151
• Station Hunting-Not Available Page 153 NOTE 1
• Voice Mail Indication Page 154 NOTE 1
For programming of the following three types of system interface, see “PROGRAMMING SUMMARY”
in this chapter. Page 91
• Analog PBX Interface
• CCIS Interface
• WCS Integrated Type
For the following features, no programming is required after the CS/PS data is programmed.
For CS/PS data programming, see “PROGRAMMING SUMMARY” in this chapter. Page 91
• Automatic Release-Out of Cell Calls
• Calling Number Display-PS NOTE 2
• Handover
• Individual PS Calling
• Out of Cell Indication
•Preset Dialing
• PS Authorization
• PS Location Registration
• Quick Dialing
• Radio Channel Changeover
•Redial-PS
• Speech Encryption
• Station Speed Dialing-PS
NOTE 1: This feature is available only for the Integrated Type.
NOTE 2: This feature is not available for the Adjunct Analog Type.
WCS FEATURE PROGRAMMING
To Next Page
Loading...
