NEC NEAX 2000 IPS - Changing CS Data in Service

CHAPTER 3 SYSTEM DATA PROGRAMMING
– 117 –
NWA-008855-001 Rev.1.0
avch3001.fm
Changing CS Data in Service
When you change the CS data (CM14, CM06, CMAD, CMAE) in service, make busy of the CS is re-
quired.
DESCRIPTION DATA
Make the CS busy. •
(1)
(2)
Y=3
000-255: CS No.
2: Make busy after calls finished
Make the CS idle. •
(1)
(2)
Y=3
000-255: CS No.
1: Make Idle
START
CME5
CM14
Change the CS data.
See
“Initial Set Up for Legacy CS”
Page 97,
or “Initial Set Up for IP-CS”.
Page 103
CM06
CMAD
CMAE
CME5
END
CS DATA PROGRAMMING