CHAPTER 3 SYSTEM DATA PROGRAMMING
ā 93 ā
NWA-008855-001 Rev.1.0
avch3001.fm
Changing CS Data in Service
When you change the CS data (CM14, CM06, CMAD, CMAE) in service, make busy of the CS is re-
quired. In this case, do the following procedure.
*
To make busy or make idle of the CS in service, assign as follows:
CME5 Y=3
(1) 000-255: CS No.
(2) 1: Make idle
2: Make busy after calls finished
MAKE BUSY OF CS
(CME5 Y=3>2)*
CHANGE OF CS DATA
(CM14, CM06, CMAD, CMAE)
MAKE IDLE OF CS
(CME5 Y=3>1)*
START
END
PROGRAMMING SUMMARY
To Next Page
Loading...
