BASIC SETTINGS/CONFIGURATION
Basic Setup with the Menus and Cursor Pad
4-82 DT700 Phone User Guide
To restart your phone
Note: Any devices connected to the phone’s PC port will momentarily disconnect
from the network when the phone is rebooted.
1 Press the Menu key.
2 Select 5 Reboot Phone.
Figure 4.52 Main menu screen
3 Press the OK softkey or b Enter key on the cursor pad to restart the phone.
Figure 4.53 Confirm Reboot
You will not have a dial tone on the phone or be able to make calls until the phone
restarts and re-registers on the network.
Note: If you cannot restart the phone using the Menus, unplug the phone from power
and the network for ten seconds, then reconnect the telephone to your
network and power to perform a
restart.
VIEWING PHONE SETTINGS
If you are having problems with your phone, you may want to view the hardware
version, firmware version, or network information for your phone.
This menu item may not be available on your phone, depending on the configuration
of your phone. Contact your system administrator for more information.
Note: You cannot change these settings on your phone. To change any of these
settings, contact your system administrator.
To view the phone settings
1 Press the Menu key.
2 Select 6 Status.
To Next Page
Loading...
