. . . . .
INSTALLATION
DT700 Phone User Guide 3-59
Figure 3.34 Screw DCL-60 module to the connector bracket
4 Connect the 10 pin connector to the SIDE 2 port on the back of the phone.
Figure 3.35 Serial Cable Installed
5 Adjust the height of the tilt leg on the phone to the desired height.
6 Adjust the height of the tilt leg on the DCL-60 to match the tilt leg on the multiline
terminal.
7 Attach the side panel to the side of the DCL-60.
8 Connect the AC Adapter cable to the DCL-60.
9 Reattach the side panel to the phone.
10 Connect power to the phone.
To install DCL-60 Line Key Card (Optional)
1 From the bottom, use an object to gently pry off the button panel for the DCL-60 module.
2 Align the holes in the Line Key Card with the buttons on the phone.
3 Align the holes in the Button Panel with the telephone keypad buttons on the phone, and
then push the four corners of the panel until the panel clicks into place.
To Next Page
Loading...
