INSTALLATION
3-58 DT700 Phone User Guide
Figure 3.31 Attach connection bracket to phone
Prepare the DCL-60 Console
1 Connect the 10 pin connector cable to the DCL-60.
2 Position the cable through the cable groove.
Figure 3.32 Press the cable into groove
Connect the DCL-60 Console to the phone
1 Press the tab on the port cover on the left side of the back of the phone to release the
protective cover that is over the SIDE 2 port. Remove the cover.
Figure 3.33 Remove SIDE 2 port cover
2 Slide the supplied DCL-60 module on to the connection bracket attached to the phone.
3 Use 2 of the supplied screws to connect the bracket to the DCL-60.
To Next Page
Loading...
