BASIC SETTINGS/CONFIGURATION
Basic Setup with the Menus and Cursor Pad
4-70 DT700 Phone User Guide
Figure 4.26 Tone Volumes options
5 Select 1 Call Waiting Volume.
Figure 4.27 Call Waiting volume
6 To change the volume level, press the Delete softkey and use the telephone keypad to
enter new volume level.
Figure 4.28 Adjust Call Waiting Volume
7 Press Enter b on the cursor pad or the OK softkey to accept the setting.
You can also press the Cancel softkey to exit without making any changes.
Note: The setting defaults to 19 (maximum tone volume).
To set the Hold Reminder volume
The Hold Reminder Volume settings allow you to specify the hold reminder volume for
the headset.
The range is 0 (no tone) to 19 (maximum tone volume). The default is 19.
Upon entering this screen, the keypad is locked in numeric entry mode. You cannot
change the keypad entry mode in this screen.
1 Press the Menu key.
2 Select 3 User Settings.
3 Select 2 Headset.
To Next Page
Loading...
