NEC UNIVERGE DT700 - Wall Mounting Clearance Requirements; To Mount the Phone on the Wall

. . . . .
INSTALLATION
DT700 Phone User Guide 3-53
Wall Mounting Clearance Requirements
The phone should be mounted to allow for the following clearances for the phone with
the DT730 (ITL-24D) shown as an example.
Figure 3.21 Wall Mounting Clearance Diagram
To mount the phone on the wall
1 Remove the handset from the handset cradle.
2 Remove the hanger piece from the handset cradle, flip it over and then turn it upside
down, and then insert it into the hanger slot until the hanger clicks.
25 mm
25 mm
35 mm
15 mm