NEC UNIVERGE DT700 - To Place an Internal Call

. . . . .
BASIC PHONE OPERATION
Basic Call Operation
DT700 Phone User Guide 7-105
The call proceeds to the dialed party.
Note: You can also dial the number, then lift the telephone handset or press the
Headset softkey to initiate a call.
INTERNAL CALLS
To place an internal call
1 Lift the handset, press the Speaker key, or press the NewCall softkey to receive dial
tone.
Figure 7.11 NewCall softkey
2 Enter the internal extension number.
You can use the Delete softkey to delete the last digit (backspace).
Figure 7.12 Enter number (internal call)
3 Press the Dial softkey to initiate the call, or wait a few seconds for the call to be
automatically dialed.
Figure 7.13 Dial softkey
The call proceeds to the dialed party.
Note: You can also dial the number, then lift the telephone handset or press the
Headset softkey to initiate a call.