. . . . .
BASIC SETTINGS/CONFIGURATION
Basic Setup with the Menus and Cursor Pad
DT700 Phone User Guide 4-69
Figure 4.23 Headset ringing options
5 Do one of the following:
• To enable ringing on the headset only, select 2 Headset..
• To enable ringing on the headset and the phoneset, select
3 Phone and Headset.
Figure 4.24 Enable Headset ringing
6 Press Enter b on the cursor pad or the OK softkey to accept the setting.
You can also press the Cancel softkey to exit without making any changes.
Note: The setting defaults to 1 Phone.
To set the Call Waiting volume
The Call Waiting Volume settings allow you to specify the call waiting tone volume for
the headset.
The range is 0 (no tone) to 19 (maximum tone volume). The default is 19.
Upon entering this screen, the keypad is locked in numeric entry mode. You cannot
change the keypad entry mode in this screen.
1 Press the Menu key.
2 Select 3 User Settings.
3 Select 2 Headset.
Figure 4.25 Select Headset options
4 Select 3 Tone Volumes.
To Next Page
Loading...
