NEC UNIVERGE DT700 - To Install Line Key Card; Wall Mounting (Optional)

INSTALLATION
3-52 DT700 Phone User Guide
To install Line Key Card
1 Align the holes in the Line Key Card with the buttons on the phone.
2 Align the holes in the Line Key Panel with the Line Key buttons on the phone, and then
push the four corners of the panel until the panel clicks into place.
3 If you need to replace the Button Panel, align the holes in the Button Panel with the
telephone keypad buttons on the phone, and then push the four corners of the panel
until the panel clicks into place.
Figure 3.20 Line Key Card Install
WALL MOUNTING (OPTIONAL)
A separate wall mount unit is used to mount the phone to the wall. This unit connects
to the back of the phone
CAUTION! BE CAREFUL NOT TO DROP THE PHONE WHILE MOUNTING IT ON
THE WALL. IT CAN CAUSE INJURY.
CAUTION! MAKE SURE THE PHONE IS FIRMLY MOUNTED ON THE WALL TO
PREVENT THE PHONE FROM FALLING OUT. IT CAN CAUSE INJURY.
Line Key
Panel
Button
Panel
Line Key Card