INSTALLATION
3-56 DT700 Phone User Guide
Figure 3.27 Connect the 8LK-L Cable
4 Connect the cable from the 8LK-L to the side option connector on the terminal and close
the cover.
5 Reattach the side panel to the phone.
To install 8LK-L Line Key Card (Optional)
1 From the bottom, use an object to gently pry off the button panel for the 8LK-L module.
2 Align the holes in the Line Key Card with the buttons on the phone.
3 Align the holes in the Button Panel with the telephone keypad buttons on the phone, and
then push the four corners of the panel until the panel clicks into place.
DCL-60 CONSOLE (TYPE A) INSTALLATION
WARNING! TO PREVENT POSSIBLE DAMAGE TO THE DCL-60 CONDOLE
OR THE PHONE TERMINAL DURING INSTALLATION OR
REMOVAL, DISCONNECT THE LINE CORD/LAN CABLE AND
THE AC/DC ADAPTER FROM THE PHONE TERMINAL TO
POWER OFF THE TERMINAL DURING THE INSTALLATION
PROCEDURE.
Note: Do not disconnect the module from a phone while the phone is powered on. If
you need to disconnect the module, power off the phone before disconnecting
the DCL-60 module.
Prepare the phone
Use the menus on the front panel of the phone to configure the Side 2 Connector port
for the DCL-60.
1 Press the Menu key.
2 Select 4 Admin Settings.
3 Use the keypad and cursor key to enter the User Name and Password to access the
Admin menu.
4 Select 3 Maintenance.
5 Select 4 Side 2 Connector Mode.
Connection
Cable
Cover
Side 1
Connector
Port
To Next Page
Loading...
