. . . . .
INSTALLATION
DT700 Phone User Guide 3-57
Figure 3.28 Side 2 Connector Mode
6 Select 2 DCL-60.
Figure 3.29 Enable DCL-60
7 Press the OK softkey.
8 Press the Exit softkey.
9 Press the Exit softkey.
10 Press the Yes softkey to restart the phone.
Note:
You must restart the phone to fully enable the DCL-60 connector mode.
11 After the phone finishes rebooting, disconnect the phone from power.
12 Remove the side panel from the phone.
Figure 3.30 Remove Side Panel from Terminal
13 Attach the connection bracket to the phone using 3 of the provided screws.
To Next Page
Loading...
