NEC UNIVERGE DT700 - Using a Headset to Make and Receive Calls; To Make Calls with Your Headset; To Answer Calls with Your Headset

BASIC PHONE OPERATION
Basic Call Operation
7-108 DT700 Phone User Guide
If you have problems reconnecting to a call after it is put on hold, press the EndCall
softkey to terminate the call.
USING A HEADSET TO MAKE AND RECEIVE CALLS
If you have a headset attached to your phone and your phone has been configured
for the headset (see “To enable an external headset” on page 4-67), you can either
use the telephone handset or your headset when you make and receive calls.
Note: You cannot attach a headset to DT710 phones.
To make calls with your headset
If you are using a headset, it is assumed that the telephone handset in the on-hook
position when you are making calls.
1 Press the NewCall softkey to receive dial tone.
2 Enter the telephone number.
3 Press the Dial softkey to initiate the call, or wait a few seconds for the call to be
automatically dialed.
Note:
You can also dial the number, then press the Headset softkey to initiate a call.
4 A Headset icon displays on the LCD along with the call information.
Figure 7.21 Headset icon and Headset softkey
5 If you want to transfer the call to your telephone handset, pick up the telephone handset
to continue the call. If you want to transfer back to the headset, press the
Headset softkey, then place the telephone handset back on-hook.
Note:
While you are on a call, if you press the Headset softkey while the telephone
handset is on-hook, your call will be dropped. Make sure you pick up the
telephone handset to continue your call before you press the Headset softkey.
To answer calls with your headset
If you are using a headset, it is assumed that the telephone handset in the on-hook
position when you are answering calls.
1 While the telephone is ringing, press the Answer key.
Figure 7.22 Answer key
2 A Headset icon displays on the LCD along with the call information.