. . . . .
PROGRAMMABLE KEYS
Speed Dial and Programmable Keys
DT700 Phone User Guide 8-127
index associated with the first and last DCL-60 Console key. All the keys from key 1 to
key 60 are numbered sequentially.
DCL-60 LEDS
Note: The LEDs on the DCL-60 Console are updated sequentially starting from the
first key on the module, so if all keys on the phone need to be updated for an
event, there may be a delay between the time the first key is updated and the
time when the last key is updated.
Each key on the DCL-60 Console has two LEDs situated at each corner of the key.
The LED on the left is red, and the LED on the right is green.
Figure 8.12 Left LED
Figure 8.13
Right LED
If the line key is configured to monitor an entry, the LED shows the current presence
state of the entry using red/green color and steady/blinking/flashing light.
DCL-60 WITH A ITL-8LD PHONE
The DCL-60 console can be connected to an ITL-8LD phone, but the lower LCD on
the phone only shows information for the first 32 programmable keys that are on the
phone. The display does not show any information about programmable keys on the
DCL-60 console.
SPEED DIAL KEY CONFIGURATION
Speed Dial Keys can be configured on the available Programmable Keys on your
phone. Speed Dial Keys allow you to use a single key to dial an internal extension
(such as a Help Desk), an external telephone number or a star/hash code.
Note: The programmed digits associated with the Speed Dial Key are dialed “as is”
by the DT700 and are not be subject to parsing or control by the DT700 local
Product
Name
Model Name
DCL-60
Mode
Max Line
Keys
DCL-60
Console
First Key
Number
DCL-60
Console Last
Key 60
Number
DT730 ITL-12D Enabled 72 13 72
ITL-24D Enabled 84 25 84
ITL-32D Enabled 92 33 92
ITL-8LD Desi-less Enabled 92 33 92
To Next Page
Loading...
