NEC UNIVERGE DT700 - To Enable or Disable the Backlight Fade (DT730 G ITL-12 CG Only)

BASIC SETTINGS/CONFIGURATION
Basic Setup with the Menus and Cursor Pad
4-76 DT700 Phone User Guide
Figure 4.44 Set Backlight Timeout
\
6 Press Enter b on the cursor pad or the OK softkey to accept the setting.
You can also press the Cancel softkey to exit without making any changes.
Note: Setting the Backlight Timeout to 0 (zero) disables the timeout, and the LCD
Backlight will remain lit at all times.
To enable or disable the Backlight Fade (DT730G ITL-12CG only)
You can enable or disable low power mode on the main screen of the color DT730G
CG phones.
Note: Although this setting is available on DT730G DG phones, it does not have any
impact on the main screen of DT730G DG phones.
1 Press the Menu key.
2 Select 3 User Settings.
3 Select 5 LCD Settings.
Figure 4.45 LCD settings
4 Select 3 LCD Low Power Mode.