. . . . .
JABRA BLUETOOTH® HEADSET SUPPORT FOR DT700 PHONES
Jabra Headset
DT700 Phone User Guide D-337
Figure D.14 HEADSET port to Jabra headset base
8 Restart the phone:
a. Press the Menu key.
b. Select 5 Reboot.
c. Press the OK softkey or b Enter key on the cursor pad to restart the phone.
Note:
If you cannot restart the phone using the Menus, unplug the phone from power
and the network for ten seconds, then reconnect the telephone to your
network and power to perform a
restart.
9 Connect the power adapter to the handset base station in accordance with the
manufacturer instructions, then run the desk phone setup wizard
(Settings\Advanced\Setup Desk Phone) on the headset base station.
a. When prompted to connect to a desk phone, select Yes. We recommend using the
Guided setup.
a. If prompted about equipment for Remote Call Control, select Yes.
b. If prompted, select Electronic hookswitch adapter.
c. When prompted for the cable type for your adapter, select UART.
d. Continue with the setup wizard, including the call to configure dial tone setup.
Follow the manufacturer’s directions for any additional connections you want to make
with the headset base.
To Next Page
Loading...
