. . . . .
INTRODUCTION TO THE DT700 AND DT730G PHONES
DT700 and DT730G Series Phones
DT700 Phone User Guide 2-25
Table 2.13 ITL-2E (DT710 Series) Keys and Parts
1 Call Indicator Lamp The Call Indicator Lamp at top corner of the display flashes
when a call is offered to the phone. Also, if you have Voice Mail
service, the Lamp lights steadily when a message has been
left.
2 Programmable Key The first programmable key is reserved as the Line Key. Line
Keys allow the user to select which line to operate on.
Any programmable keys not used as Line Keys can be
programmed as Speed Dial Keys by the user or system
administrator. Numbers up to 24 digits can be assigned to
Speed Dial Keys. The numbers may be a telephone number or
star/hash codes.
3Recall key
3C systems:
Press this key to get a dial tone. If you are currently on a call,
the current call will be placed on hold and a new call will be
started.
SIP@Net Platforms:
See the Hold key.
4 Feature key This key does not have a function on the ITL-2E phone.
5 Redial Key Press this key to redial the last number that was dialed.
6 Conf Key Press key to establish a 3-way conference call. The LED on
this key lights when are establishing a 3-way conference call,
and turns off when you end the conference call.
7 Answer key Press this key to answer an incoming call. The audio will go
through the speaker on the phone.
When LED on this key is lit, press key to answer a waiting call.
8 Mic key Press key to mute the microphone. The LED on this key
flashes when the microphone is muted. Press the key again to
un-mute the microphone.
9 Message Key Press key to access the voice mail system.
10 Directory Key This key is not currently supported.
11 Hold key Press this key to place a call on hold.
12 Transfer key Press this key to transfer a call.
13 Speaker key Controls the built-in speaker which can be used for Hands
Free dialing and conversations.
The LED on this key lights when the speaker is active.
14 Up/Down Key Used to adjust various volume levels.
• Handset, Speaker and Headset volume:
Press (UP) or (DOWN) key during conversation.
• Ring Volume:
Press (UP) or (DOWN) key while on hook.
• Soft Ring Volume:
Press (UP) or (DOWN) key while Soft Ring is playing.
To Next Page
Loading...
