NETGEAR FVS318N

Wireless Configuration and Security
100
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
3. Specify the settings as explained in the following table:
4. Click Apply
to save your settings. The new VAP is added to the List Of Available Access
Points table.
 To enable or disable one or more VAPs:
1. On
the Access Point screen (see Figure 48 on page 98), select the check box to the left
of each VAP that you want to enable or disable, or click the Select All t
able button to
select all VAPs.
2. Click one
of the following table buttons:
• Enabl
e. Enables the VAP or VAPs and allows wireless clients to make a connection.
• Disab
le. Disables the VAP or VAPs and prevents wireless clients from making a
connection.
 To edit a VAP:
1. On
the Access Point screen (see Figure 48 on page 98), click the Edit button in the
Action column for the VAP that you want to modify. The Edit Access Point screen
displa
ys. This screen is identical to the Add Access Point screen.
2. Modif
y the settings as explained in the previous table.
3. Click Apply to save
your settings.
Table 24. Add Access Point screen settings
Settings Description
AP Name The name for the default VAP is ap1. You cannot change this name. For
add
itional VAPs, enter a unique name to make it easy to recognize the profile.
You can enter a value of up to 32 alphanumeric characters.
Profile Name From the drop-down list, select the profile th
at should be allocated to the VAP.
VLAN From the drop-down list, select the VLAN to which the VAP should be allocated.
Active Time To enable the timer, select the Ac
tive Time check box. When the timer is
enabled, the VAP is turned off from the start time until the stop time. To disable
the timer, clear the check box.
Start Time Specify the start hour in the Hours field and the start minute in the Minutes field,
and
then select AM or PM from the drop-down list.
Stop Time Specify the stop hour in the Hours field and the stop minute in the Minutes field,
and then select AM or PM from the drop-down list.
WLAN Partition To enable wireless client separation and pre
vent wireless clients that are
connected to this VAP from communicating with each other, select the WLAN
Partition check box. The disable wireless client separation, clear the check
box. By default, WLAN partition is disabled.