NETGEAR FVS318N

Virtual Private Networking Using IPv4 IPSec and L2TP Connections
178
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
interval period, enter a new value in the Poll Interval field, and then click the Set Interval
button. To stop polling, click the Stop button.
View the Wireless VPN Firewall IPSec VPN Log
 To display the IPSec VPN log:
Select Monitoring > VPN Logs
> IPSec VPN Logs. The IPSec VPN Logs screen displays.
Figure 109.
Table 42. IPSec VPN Connection Status screen information
Item Description
Policy Name The name of the VPN policy that is associated with this SA.
Endpoint The IP address on the remote VPN endpoint.
Tx (KB) The amount of data that is transmitte
d over this SA.
Tx (Packets) The number of IP packets that are transmitted over this SA.
State The current status of the SA. Phase 1 is the
authentication phase, and Phase 2 is key
exchange phase. If there is no connection, the status is IPSec SA Not Established.
Action Click the Co
nnect table button to build the connection, or click the Disconnect table
button to terminate the connection.