NETGEAR FVS318N

IPv4 Firewall Protection
134
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
3. Click Apply to save your settings.
Set Session Limits
The session limits feature allows you to specify the total number of sessions that are allowed,
per user, over an IP connection across the wireless VPN firewall. The session limits feature is
disabled by default.
 To enable and configure session limits:
1. Select Security > Firewall > Sess
ion Limit. The Session Limit screen displays:
Figure 69.
Multicast Pass through
Enable IGMP IP multicast pass-through allows multicast packets that originate in the WAN subnet,
such as packets from a media streaming or gaming application, to be forwarded to
the LAN subnet. Internet Group Management Protocol (IGMP) is used to support
multicast between IP hosts and their adjacent neighbors.
Select the Enable IGMP check box to enable IP multicast pass-through. By default,
IP multicast pass-through is disabled.
Jumbo Frames
Enable Jumbo
Frame
Jumbo frames allow multiple smaller packets to be combined into a single larger
packet, reducing network overhead and increasing data transfer performance.
Select the Jumbo Frame check box to enable jumbo frames. By default, jumbo
frames are disabled.
Note: Jumbo frames are not supported on F
ast Ethernet interfaces.
Table 29. Attack Checks screen settings (continued)
Setting Description