Virtual Private Networking Using IPv4 IPSec and L2TP Connections
160
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Figure 86.
b. Locate the policy in the table, and click the Connect table button. The IPSec VPN
connection becomes active.
Note: When using FQDNs, if the Dynamic DNS service is slow to update
its servers when your DHCP WAN address changes, the VPN tunnel
will fail because the FQDNs do not resolve to your new address. If
you have the option to configure the update interval, set it to an
appropriately short time.
Create a Client-to-Gateway VPN Tunnel
Figure 87.
To configure a VPN client tunnel, follow the steps in the following sections:
• Use the VPN Wizard to Configure the Gateway for a Client Tunnel o
n page 161.
• Use the NETGEAR VPN Client Wizard to Create a Secure Connection on
page 163 or
Manually Create a Secure Connection Using the NETGEAR VPN Client on page 168.
To Next Page
Loading...
