NETGEAR FVS318N

Internet and Broadband Settings
34
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
3. In the DHCPv6 section of the screen, select one of the following radio buttons:
• S
tateless Address Auto Configuration.
• S
tateful Address Auto Configuration.
4. Click Apply to
save your changes.
5. T
o verify the connection, click the Broadband Status (IPv6) option arrow in the upper right
of the screen to display the Connection Status pop-up screen. (The following figure shows a
dynamic IP address configuration.)
Figure 16.
The Connection Status screen should show a valid IP address and gateway, and you are
connected to the Internet. If the configuration was not successful, see Troubleshoot the
ISP Connection on p
age 323.
Note: For more information about the Connection Status screen, see View
the WAN Port Status on page 311.
Manually Configure an IPv6 Internet Connection
To manually configure an IPv6 Internet connection, you need to receive static IP address
information from your ISP.
 To manually configure the IPv6 broadband ISP settings:
1. Select Netwo
rk Configuration > WAN Settings > Broadband ISP Settings (IPv6).
The Broadband ISP Settings (IPv6) screen displays: