Default Settings and Technical Specifications
333
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Physical and Technical Specifications
The following table shows the physical and technical specifications for the wireless VPN
firewall:
Wireless radio and access point
Wireless radio Enabled
Default virtual access point ap1
Default network name (SSID) FVS318N_1
Broadcast SSID Enabled
Default security profile default1
Security Open, no encryption
Transmission rate Best
1
Country and region Unites States
802.11 wireless mode 802.11ng
80211b/g/n radio frequency channel Auto
80211n channel spacing 20 MHz
80211n control side band Lower
1. The maximum wireless signal rate derived from IEEE Standard 802.11 specifications. The actual throughput varies. Network conditions and
environmental factors, including volume of network traffic, building materials and construction, and network overhead, lower actual data
throughput rate.
Table 82. Wireless VPN firewall physical and technical specifications
Feature Specification
Network protocol and standards compatibility
Data and Routing Protocols TCP/IP, RIP-1, RIP-2, PPP over Ethernet (PPPoE),
DHCP, DHCPv6
Power plug (localized to the country of sale)
North America 120V, 60 Hz, input
United Kingdom, Australia 240V, 50 Hz, input
Europe 230V, 50 Hz, input
Input, for all regions 12VDC @ 1A output
Table 81. Wireless VPN firewall factory default configuration settings (continued)
Feature Default behavior
To Next Page
Loading...
