Introduction
17
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Rear Panel
The rear panel of the wireless VPN firewall includes a cable lock receptacle, a console port, a
Reset button, and a DC power connection.
Rear Panel
Figure 2.
Viewed from left to right, the rear panel contains the following components:
1. Det
achable dipole antenna.
2. Cable
security lock receptacle.
3. Console
port. Port for connecting to an optional console terminal. The port has a DB9 male
connector. The default baud rate is 9600 K. The pinouts are (2) Tx, (3) Rx, (5) and (7) Gnd.
4. Factory def
ault Reset button. Using a sharp object, press and hold this button for about
8 seconds until the front panel Test LED flashes to reset the wireless VPN firewall to factory
default
settings. All configuration settings are lost, and the default password is restored.
5. DC po
wer plug receptacle. Power input is 12VDC, 1A. The power plug is localized to the
country of sale.
6. Power On/Of
f switch.
7. Det
achable dipole antenna.
(2) Security lock
receptacle
(3) Console port
(4) Factory default
(5) DC power
receptacle
Reset button
Antennas
(6) Power
(1) and (7)
switch
To Next Page
Loading...
