NETGEAR FVS318N

Internet and Broadband Settings
27
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Figure 10.
The Connection Status screen should show a valid IP address and gateway, and you are
connected to the Internet. If the configuration was not successful, skip ahead to Manually
Configure an IPv4 Internet Connection on p
age 27, or see Troubleshoot the ISP
Connection o
n page 323.
Note: For more information about the Connection Status screen, see View
the WAN Port Status on page 311.
If the automatic WAN ISP configuration is successful, you can skip ahead to Configure th
e
IPv4 WAN Mode on page 31.
Manually Configure an IPv4 Internet Connection
Unless your ISP automatically assigns your configuration through a DHCP server, you need
to obtain configuration parameters from your ISP to manually establish an Internet
connection. The required parameters for various connection types are listed in Table 2 on
page 26.
 To manually configure the IPv4 broadband ISP settings:
1. Select Network Configuratio
n > WAN Settings > Broadband ISP Settings (IPv4).
The ISP Broadband Settings (IPv4) screen displays (see Figure 9 on p
age 25).
2. Locate the IPS Login
section on the screen:
Figure 11.