NETGEAR FVS318N

Wireless Configuration and Security
98
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Note: If WPS is enabled for the security profile, first disable WPS before
you delete the security profile.
Configure Virtual Access Points
You can configure up to four virtual access points (VAPs) on the wireless VPN firewall. All
VAPs can be active simultaneously to accommodate different types of clients. You can assign
only a single security profile to each VAP, and the same security profile cannot be assigned to
more than one VAP.
Each VAP provides the following features:
• Cap
ability to turn off the VAP during scheduled vacations and office shutdowns, on
evenings, or on weekends. This a green feature that allows you to save energy.
• WL
AN partitioning to prevent associated wireless clients (using the same VAP) from
communicating with each other. This feature is useful for hotspots and other public
access situations.
• MAC a
ddress access control list that lets you add another level of security.
• Cap
ability to monitor the VAP and its connected clients.
 To add a VAP:
1. Select Network Config
uration > Wireless Settings > Access Point. The Access Point
screen displays. (The following figure shows some examples.)
Figure 48.