NETGEAR FVS318N

Troubleshooting
330
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Address Problems with Date and Time
The System Date & Time screen displays the current date and time of day (see Configure
Date and Time Service o
n page 288). The wireless VPN firewall uses the Network Time
Protocol (NTP) to obtain the current time from on
e of several network time servers on the
Internet. Each entry in the log is stamped with the date and time of day.
Problems with the date and time function can include:
• Date
shown is January 1, 2000. Cause: The wireless VPN firewall has not yet
successfully reached a network time server. Check that your Internet access settings are
configured correctly. If you have just completed configuring the wireless VPN firewall, wait
at least 5 minutes, and check the date and time again.
• T
ime is off by 1 hour. Cause: The wireless VPN firewall does not automatically sense
daylight savings time. Go to the Time Zone screen, and select or clear the Automatically
Adjust for Daylight Savings Time check box.
Access the Knowledge Base and Documentation
 To access NETGEAR’s knowledge base for the wireless VPN firewall:
Select Support > Knowledg
e Base.
 To access NETGEAR’s documentation library for your wireless VPN firewall model:
Select Support > Doc
umentation.