Troubleshooting
329
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Figure 189.
b. Click the Default button.
The wireless VPN firewall reboots. During the reboot process, the Settings Backup and
F
irmware Upgrade screen might remain visible, or a status message with a counter might
show the number of seconds left until the reboot process is complete. The reboot process
takes about 160 seconds. (If you can see the unit: The reboot process is complete when the
Test LED on the front panel goes off.)
When you press the hardware factory default Reset button or click
the software Default button, the wireless VPN firewall settings are
erased. All firewall rules, VPN policies, LAN and WAN settings,
and other settings are lost. Back up your settings if you intend on
using them.
Note: After rebooting with factory default settings, the wireless VPN
firewall’s password is password, and the LAN IP address is
192.168.1.1.
To Next Page
Loading...
