NETGEAR FVS318N

Virtual Private Networking Using IPv4 IPSec and L2TP Connections
156
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Use the IPSec VPN Wizard for Client and Gateway
Configurations
You can use the IPSec VPN Wizard to configure multiple gateway or client VPN tunnel
policies.
The following section provides wizard and NETGEAR ProSafe VPN Client software
con
figuration procedures for the following scenarios:
• Using th
e wizard to configure a VPN tunnel between two VPN gateways
• Using th
e wizard to configure a VPN tunnel between a VPN gateway and a VPN client
Configuring a VPN tunnel connection requires that you specify all settings on both sides of
the VPN tunn
el to match or mirror each other precisely, which can be a daunting task. The
VPN Wizard efficiently guides you through the setup procedure with a series of questions that
determine the IPSec keys and VPN policies it sets up. The VPN Wizard also configures the
settings for the network connection: security association (SA), traffic selectors, authentication
algorithm, and encryption. The settings that are used by the VPN Wizard are based on the
recommendations of the VPN Consortium (VPNC), an organization that promotes
multivendor VPN interoperability.
Create a Gateway-to-Gateway VPN Tunnel with the Wizard
Figure 82.

To set up a gateway-to-gateway VPN tunnel using the VPN Wizard:
1. Select VPN > IPSec VPN > VPN W
izard. The VPN Wizard screen displays. (The
following screen contains some examples that do not relate to other examples in this
manual.)