NETGEAR FVS318N

LAN Configuration
78
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
 To edit an IPv4 static route:
1. On the IPv4 Static Routing screen (see Figure 39 on page 76), click the Edit button in
the Action column for the route that you want to modify. The Edit Static Route screen
displa
ys. This screen is identical to the Add Static Route screen (see the previous
screen).
2. Modif
y the settings as explained in the previous table.
3. Click Apply to save
your settings.
 To delete one or more routes:
1. On
the IPv4 Static Routing screen (see Figure 39 on page 76), select the check box to
the left of each route that you want to delete, or click the Selec
t All table button to select
all routes.
2. Click the Delete t
able button.
Configure the Routing Information Protocol
Routing Information Protocol (RIP), RFC 2453, is an Interior Gateway Protocol (IGP) that is
commonly used in internal IPv4 networks (LANs). RIP enables a router to exchange its
routing information automatically with other routers, to dynamically adjust its routing tables,
and to adapt to changes in the network. RIP is disabled by default. RIP does not apply to
IPv6.
 To enable and configure RIP:
1. Select Netwo
rk Configuration > Routing > IPv4 Static Routing.
2. Click the RI
P Configuration option arrow to the right of the Routing submenu tab. The RIP
Configuration screen displays: