NETGEAR FVS318N

LAN Configuration
56
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
 To edit a VLAN profile:
1. On the LAN Setup (IPv4) screen (see Figure 27 on page 51), click the Edit button in the
Action column for the VLAN profile that you want to modify. The Edit VLAN Profile
screen displays. This screen is ide
ntical to the Add VLAN Profile screen (see the
previous screen).
2. Modif
y the settings as explained in the previous table.
3. Click Apply to save
your settings.
 To enable, disable, or delete one or more VLAN profiles:
1. On
the LAN Setup (IPv4) screen (see Figure 27 on page 51), select the check box to the
left of each VLAN profile that you want to enable, disable, or delete, or click the Se
lect
All table button to select all profiles. (You cannot select the default VLAN profile.)
2. Click one
of the following table buttons:
• Enable. En
ables the VLAN or VLANs. The ! status icon changes from a gray circle to
a green circle, indicating that the selected VLAN or VLANs are enabled. (By default,
when a VLAN is added to the table, it is automatically enabled.)
• Disable. Disable
s the VLAN or VLANs. The ! status icon changes from a green circle
to a gray circle, indicating that the selected VLAN or VLANs are disabled.
• Delete. Deletes the VLAN
or VLANs.
Configure VLAN MAC Addresses and LAN Advanced Settings
By default, all configured VLAN profiles share the same single MAC address as the LAN
ports. (All LAN ports share the same MAC address.) However, you can change the VLAN
MAC settings to allow up to 16 VLANs to each be assigned a unique MAC address.
You can also enable or disable the broadcast of Address Resolution Protocol (ARP) packets
for the default VLAN. If the broadcast of ARP packets is enabled, IP addresses can be
mapped to physical addresses (that is, MAC addresses).
 To configure a VLAN to have a unique MAC address:
1. Select Netwo
rk Configuration > LAN Settings. The LAN submenu tabs display, with
the LAN Setup (IPv4) screen in view (see Figure 27 on p
age 51).
2. Click the Advan
ced option arrow in the upper right of the LAN Setup (IPv4) screen. The
IPv4 LAN Advanced screen displays: