NETGEAR FVS318N

Wireless Configuration and Security
103
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
 To enable WPS and initiate the WPS process on the wireless VPN firewall:
1. Select Network Configuration > Wireless Settings > Profiles. The Profiles screen
displays (see Figure 46 on
page 93).
2. Click the WPS o
ption arrow in the upper right of the Radio Settings screen. The WPS
screen displays.
Figure 51.
3. From the WPS Status drop-down list, select Enabled to enable the WPS feature.
4. Click App
ly to save your changes.
Note: The Select Virtual AP, Security, Authentication, and Encryption fields
a
re nonconfigurable fields that are for information only.
5. In t
he WPS Setup Method section of the screen, use one of the following methods to initiate
the WPS process for a wireless device:
• PIN meth
od:
a. Collect the pin of the wir
eless device.
b. I
n the Station PIN field, enter the pin.
c. Click the PIN butto
n.
• Push
button configuration (PBC) method:
a. Click the PBC b
utton.
b. W
ithin 2 minutes, press the WPS button on your wireless device to enable the
device to connect the access point of the wireless VPN firewall, or follow the
WPS instructions that came with the device.