NETGEAR FVS318N

IPv4 Firewall Protection
120
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
To access the DMZ WAN Rules screen, select Security > Firewall > DMZ WAN Rules. The
DMZ WAN Rules screen displays. (The following figure shows a rule in the Outbound
Services table as an example.)
Figure 57.

To make changes to an existing outbound or inbound service rule:
In the Action column to the right of to the rule, click one of the following table buttons:
• Up. Move
s the rule up one position in the table rank.
• Down. Mo
ves the rule down one position in the table rank.
• Edit. Allo
ws you to make any changes to the definition of an existing rule. Depending on
your selection, either the Edit DMZ WAN Outbound Service screen (identical to Figure 58
on page 121) or the Edit DMZ WAN Inbound Service screen (identical to Figure 59 on
page 122) displays, containing the data for the selected rule.
 To enable, disable, or delete one or more rules:
1. select
the check box to the left of each rule that you want to enable, disable, or delete,
or click the Select All table button to select all rules.
2. Click one
of the following table buttons:
• Enabl
e. Enables the rule or rules. The ! status icon changes from a gray circle to a
green circle, indicating that the selected rule or rules are enabled. (By default, when a
rule is added to the table, it is automatically enabled.)
• Disab
le. Disables the rule or rules. The ! status icon changes from a green circle to a
gray circle, indicating that the selected rule or rules are disabled.
• Delete. Delete
s the selected rule or rules.