NETGEAR FVS318N

Introduction
15
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Figure 1.
The following table describes the function of each LED.
Table 1. LED descriptions
LED Activity Description
Power LED On (green) Power is supplied to the wireless VPN firewall.
Off Power is not supplied to the wireless VPN firewall.
Test LED On (amber) during
startup.
Test mode. The wireless VPN firewall is initializing. After approximately 2
minutes, when the wireless VPN firewall has completed its initialization, the
Test LED goes off.
On (amber) during
any other time
The initialization has failed, or a hardware failure has occurred.
Blinking (amber) The wireless VPN firewall is writing to flash memory (during upgrading or
resetting to defaults).
Off The wireless VPN firewall has booted successfully.
Power
Test LED
DMZ LED
Left WAN LED
Right WAN LED
Active WAN LED
Wireless LED
LED
Left LAN LEDs
Right LAN LEDs
(green, one for each port)
(white, one for each port)
(green)
(white)