NETGEAR FVS318N

Virtual Private Networking Using IPv4 IPSec and L2TP Connections
158
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Figure 84.
2. Complete the settings as explained in the following table:
Table 35. IPSec VPN Wizard settings for a gateway-to-gateway tunnel
Setting Description
About VPN Wizard
This VPN tunnel will connect
to th
e following peers
Select the Gateway radio button. The local WAN port’s IP address or
Internet name displays in the End Point Information section of the screen.
Connection Name and Remote IP Type
What is the new Connection
Na
me?
Enter a descriptive name for the connection. This name is used to help you
to manage the VPN settings; the name is not supplied to the remote VPN
endpoint.
What is the pre-shared key? Enter a pre-shared key. The key needs to be entered both here and on the
re
mote VPN gateway. This key needs to have a minimum length of
8 characters and should not exceed 49 characters.
End Point Information
a
What is the Remote WAN’s IP
Address or Internet Name?
Enter the IP address or Internet name (FQDN) of the WAN interface on the
remote VPN tunnel endpoint.
What is the Local WAN’s IP
Address or Internet Name?
When you select the Gateway radio button in the About VPN Wizard
section of the screen, the IP address of the wireless VPN firewall’s active
WAN interface is automatically entered.