Virtual Private Networking Using IPv4 IPSec and L2TP Connections
202
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
4. Click Apply to save your settings. The new Mode Config record is added to the List of Mode
Config Records table.
Continue the Mode Config configuration procedure by configuring an IKE policy.
5. Select VP
N > IPSec VPN. The IPSec VPN submenu tabs display with the IKE Policies
screen in view (see Figure 110 o
n page 180).
6. Under
the List of IKE Policies table, click the Add table button. The Add IKE Policy screen
displays.
Integrity Algorithm From the drop-down list, select one of the following two algorithms to be used in the
VPN header for the authentication process:
• SHA-1. Ha
sh algorithm that produces a 160-bit digest. This is the default setting.
• MD5.
Hash algorithm that produces a 128-bit digest.
Local IP Address The local IP address to which remote VPN clients have access. If you do not
specify a local IP address, the wireless VPN firewall’s default LAN IP address is
used (by default, 192.168.1.1).
Local Subnet Mask The local subnet mask. Typically, this is 255.255.255.0.
Note: If you do not specify a local IP address, you do
not need to specify a subnet
either.
Table 49. Add Mode Config Record screen settings (continued)
Setting Description
To Next Page
Loading...
