NETGEAR FVS318N - Page 211

Virtual Private Networking Using IPv4 IPSec and L2TP Connections
211
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Note: This is the name for the IPSec configuration that is used only for the
VPN client, not during IPSec negotiation. You can view and change this name
in the tree list pane. This name needs to be a unique name.
The IPSec pane displays in the Configuration Panel screen, with the
IPSec tab selected
by default.
Figure 122.
3. Specify the settings that are explained in the following table.
Table 53. VPN client IPSec configuration settings (Mode Config)
Setting Description
VPN Client
addre
ss
This field is masked out because Mode Config is selected. After an IPSec connection is
established, the IP address that is issued by the wireless VPN firewall displays in this field
(see Figure 127 on p
age 215).
Address Type Select Sub
net address from the drop-down list.
Remote host
addre
ss
The address that you need to enter depends on whether or not you have specified a LAN
IP network address in the Local IP Address field on the Add Mode Config Record screen
of the wireless VPN firewall:
• If you left the Local IP Address field blank, enter the wireless VPN firewall’s default LAN
IP ad
dress as the remote host address that opens the VPN tunnel. For example, enter
192.168.1.1.
• If you specified a LAN IP network address in th
e Local IP Address field, enter the
address that you specified as the remote host address that opens the VPN tunnel.