NETGEAR FVS318N

Internet and Broadband Settings
29
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
6. In the Internet (IP) Address section of the screen (see the following figure), configure the IP
address settings as explained in the following table. Click the Current IP Address link to
see the currently assigned IP address.
Austria (PPTP)
(continued)
My IP Address The IP address assigned by the ISP to make the connection with the
ISP server.
Server IP
Address
The IP address of the PPTP server.
Other (PPPoE) If you have installed login software, then your connection type is PPPoE. Select this radio
button, and enter the following settings:
Account Name The valid account name for the PPPoE connection.
Domain Name The name of your ISP’s domain or your domain name if your ISP has
assigned one. You can leave this field blank.
Idle Timeout Select the Keep Connected radio button to keep the connection always
on. To log out after the connection is idle for a period of time, select the
Idle Timeout radio button and, in the time-out field, enter the number of
minutes to wait before disconnecting. This is useful if your ISP charges
you based on the period that you have logged in.
Connection
Reset
Select the Connection Reset check box to specify a time when the
PPPoE WAN connection is reset, that is, the connection is disconnected
momentarily and then reestablished. Then, specify the disconnect time
and delay.
Disconnect
Time
Specify the hour and minutes when the connection should
be disconnected.
Delay Specify the period in seconds after which the connection
should be reestablished.
Table 3. PPTP and PPPoE settings (continued)
Setting Description