NETGEAR FVS318N

Monitor System Access and Performance
312
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Depending on the type of connections, any of the following buttons might display on the
Connection Status screen:
• Renew. Click to renew the DHCP lease.
• Release. Click to disconnect the DHCP connection.
• Disco
nnect. Click to disconnect the static IP connection.
IPv6 WAN Port Status
 To view the IPv6 status of the WAN port:
1. Select Netwo
rk Configuration > WAN Settings > Broadband ISP Settings (IPv6).
The Broadband ISP Settings (IPv6) screen displays (see Figure 15 on p
age 33).
2. Click the Bro
adband Status (IPv6) option arrow in the upper right of the screen to display
the Connection Status pop-up screen. (The following figure shows a dynamic IP address
configuration.)
Connection Status The connection status can be either Connected or Disconnected.
IP Address The addresses that were automatically detected or that you configured on the
Broadband ISP Settings (IPv4) screen.
Note: For more information, see Let the Wireless VPN Firewall Automatically
Detect
and Configure an IPv4 Internet Connection on page 25 and Manually Configure an
IPv4 Internet Connection on pag
e 27.
Subnet Mask
Gateway
DNS Server
DHCP Server DHCP only. The DHCP server that was automatically detected. This field displays
only if your ISP does not require a login and the IP address is acquired dynamically
from your ISP. You have configured these ISP settings on the Broadband ISP
Settings screen.
Note: For more information, see Let the Wireless VPN Firewall Automatically
Detect
and Configure an IPv4 Internet Connection on page 25 and Manually Configure an
IPv4 Internet Connection on pag
e 27.
Lease Obtained DHCP only. The time when the DHCP lease was obtained.
Lease Duration DHCP only. The period that the DHCP lease remains in effect.
Table 79. Connection Status screen information for an IPv4 connection (continued)
Item Description