NETGEAR FVS318N

Troubleshooting
325
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Windows Server 2003, all versions
- W
indows server 2003 R2, all versions
- L
inux and other UNIX-based systems with a correctly configured kernel
- MAC O
S X
• Make sure tha
t IPv6 is enabled on the computer. On a computer that runs a
Windows-based operating system, do the following (note that the steps might differ on the
various Windows operating systems):
a. Open
the Network Connections screen or the Network and Sharing Center screen.
For example, on the Windows taskbar, click Start, then select Control Panel, and
then Network Connections.
b. Click or
double-click Local Area Connection for the connection to the wireless VPN
firewall. The Local Area Connection Properties screen displays:
Figure 186.
c. Make sure that Internet Protocol Version 6 (TCP/IPv6) displays, as is shown on the
previous screen.
• Make sure tha
t the computer has an IPv6 address. If the computer has a link-local
address only, it cannot reach the wireless VPN firewall or the Internet. On a computer that
runs a Windows-based operating system, do the following (note that the steps might differ
on the various Windows operating systems):
a. Open
the Network Connections screen or the Network and Sharing Center screen.
For example, on the Windows taskbar, click Start, then select Control Panel, and
then Network Connections.
b. Click or
double-click Local Area Connection for the connection to the wireless VPN
firewall.