NETGEAR FVS318N

LAN Configuration
67
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
3. Click Apply to save your changes.
IPv6 Address Pools
If you configure a stateful DHCPv6 server, you need to add local DHCP IPv6 address pools
so the DHCPv6 server can control the allocation of IPv6 addresses.
 To add an IPv6 address pool:
1. On the LAN
Setup (IPv6) screen, under the List of IPv6 Address Pools table, click Add.
The LAN IPv6 Config screen displays.
Figure 35.
2. Enter the settings as explained in the following table:
3. Click App
ly to save your changes and add the new IPv6 address pool to the List of IPv6
Address Pools table on the LAN Setup (IPv6) screen.
 To edit an IPv6 address pool:
1. On the LAN Setup (IPv6
) screen (see Figure 34 on page 65), click the Edit button in the
Action column for the address pool that you want to modify. The LAN IPv6 Config
scre
en displays.
2. Mo
dify the settings as explained in the previous table.
3. Click App
ly to save your settings.
Table 13. LAN IPv6 Config screen settings
Setting Description
Start IPv6 Address Enter the start IP address. This address specifies the first of the contiguous
addresses in the IP address pool. Any new DHCPv6 client joining the LAN is
assigned an IP address between this address and the end IP address.
End IPv6 Address Enter the end IP address. This address specifies the last of the contiguous
addresses in the IP address pool. Any new DHCPv6 client joining the LAN is
assigned an IP address between the start IP address and this IP address.
Prefix Length Enter the IPv6 prefix length, for example /10 or /64.